If you want to update the firmware of your D-Link wireless range extender, it is important that you access the official login page of your device. What happened? Are you unable to access the D-Link extender login page via dlinkap.local? Does the dlinkap.local not working error message pop up on your screen every time that you try to log in to your extender? Well, that is unfortunate. But, worry not. Simply walk through the troubleshooting hacks mentioned in this post and learn how to get rid of the dlinkap.local not working issue in a matter of minutes.
Fixed: Dlinkap.local Not Working Issue
- Reboot Your D-Link Extender
One of the biggest reasons leading you to the dlinkap.local not working issue are technical glitches. To get rid of these glitches, all you need to do is, reboot your D-Link wireless range extender. Walk through the instructions mentioned below and learn how to give your device a proper restart:
- Disconnect your extender from your home router.
- Turn off your D-Link extender and unplug it from its wall socket.
- Wait for a couple of seconds.
- Plug your D-Link extender back into its wall socket and turn it on.
- Reconnect your extender to your home router.
Now, check whether you are able to access dlinkap.local or not. If not, it is recommended that you follow the next troubleshooting hack.
- Use the Correct Web Address
Many users commit the mistake of not entering the correct web address in the address bar of their web browsers. Are you making the same mistake? If you are nodding your head in yes, then consider rectifying it by using the correct web address to log in to your D-Link wireless range extender.
- Update Your Web Browser
Another common reason why you are stuck with the dlinkap.local not working issue is because your web browser is not running on an updated version. Thus, update your web browser by going to its Settings menu and clicking the Update Browser button.
Also, to be on the safer side, make sure your browser is free of cache and browsing history.
- Check the Ethernet Connection
Verify the Ethernet cable connecting your Dlink WiFi extender and your home router. Is it worn out or damaged from anywhere? Yes? Well, in that case, consider replacing your Ethernet cable with a brand new one. Don’t want to do that? Connect your devices with the help of a wireless medium then.
- Pull Your Devices Closer
Is your D-Link wireless range extender placed away from your home router? Well, that is exactly where you went wrong. You shouldn’t have placed your devices far from each other. This one little mistake has made it difficult for them to transmit signals.
Therefore, unplug your extender from the wall socket it is currently plugged into and then plug it into the one located near your home router.
- Avoid Signal Interference
Make sure that your D-Link wireless range extender is not placed near cordless phones, washing machines, baby monitors, Bluetooth speakers, mirrors, fish tanks, treadmills, televisions, refrigerators, microwave ovens, aluminum studs, corners, concrete walls, and utensils containing a large amount of water.
- Reset Your D-Link Extender
Are you still struggling because of the dlinkap.local not working issue? In that scenario, your last resort is to perform factory default reset.
Follow the instructions mentioned below and learn how to reset your wireless device:
- Find the Reset button on your D-Link wireless range extender.
- Once found, carefully press it using sharp object.
- Wait for a couple of seconds.
Once you are done resetting your D-Link wireless range extender, set it up from scratch by referring to the guidelines given in the user manual.
Note: If you are also facing the dlinkrouter local not working issue with your D-Link wireless router, then you can take the help of the same steps mentioned above.
We hope that after following the troubleshooting hacks given in this article, you were able to get rid of the dlinkap.local not working issue. Now, you can easily log in to your D-Link wireless range extender and update its firmware to the latest version.
