Being a networking device, a Wireless-N WiFi repeater can fall victim to issues at any time. One of the most annoying issues is Wireless-N WiFi repeater won’t connect. Are you also going nuts because of the same issue? Yes? No worries! This post will put a happy ending to your miserable story. So, read on.<\/p>\n\n\n\n
Fixed: Wireless-N Repeater Won’t Connect to 5GHz<\/strong><\/p>\n\n\n\n Perhaps, your Wireless-N WiFi repeater has fallen victim to technical glitches. Know that technical glitches are unexpected errors that can make your repeater non-functional too. So, without wasting time, consider rebooting your Wireless-N WiFi repeater. FYI, rebooting the repeater is one of the most effective methods to resolve technical glitches.<\/p>\n\n\n\n You can reboot your Wireless-N repeater by unplugging it from the wall socket, letting it rest, and plugging it back after some time. Now, check whether your repeater connects to 5GHz. If it doesn’t, refer to the next troubleshooting technique.<\/p>\n\n\n\n Are you aware that your Wireless-N repeater runs on a software called firmware? Well, now you are. If you keep the firmware of your repeater updated, everything will work fine. If not, then you destine yourself to face issues similar to the one you are already facing. So, update the firmware of your right away by accessing the Wireless N WiFi repeater login<\/a> <\/strong>screen.<\/p>\n\n\n\n In case you are unaware of the Wireless-N repeater firmware update process, refer to the steps given below:<\/p>\n\n\n\n This is how you can go about the firmware update process of your Wireless-N WiFi repeater.<\/p>\n\n\n\n Chances are that there is a huge distance between your Wireless-N repeater and the host router due to which the 5GHz signals are not getting detected. Thus, consider reducing the distance between your WiFi devices. But, keep in mind that reducing the distance never means that both devices should stick to each other. Doing so can make your internet experience worst as the WiFi signals of both devices will clash.<\/p>\n\n\n\n In the case of a wired connection, make sure that the Ethernet or network cable connecting your Wireless-N WiFi repeater and router is not damaged from any point. If it is, we recommend you replace it with a new one right away. Also, remember the principle of a finger-tight connection.<\/p>\n\n\n\n Perhaps there is WiFi interference present in the path of your repeater’s and router’s signals. So, you need to get rid of WiFi interference. Some of the WiFi interference-creating factors are metal objects like doors, utensils, boxes, etc. Apart from this, reflexive surfaces and masonry constructions can also block your repeater’s WiFi signals.<\/p>\n\n\n\n In addition to this, keep your repeater away from devices emitting radiowaves like microwave ovens, cellular phones, baby monitors, televisions, Bluetooth speakers, etc.<\/p>\n\n\n\n Tried all of the aforementioned troubleshooting hacks and still your repeater is not detecting 5GHz signals? Well, it looks like your repeater is not set in a proper manner. Thus, you need to configure it properly. However, before that, reset it to the factory default mode.<\/p>\n\n\n\n Given below are the steps explaining the Wireless-N repeater reset process:<\/p>\n\n\n\n